-
Description
- Wide temperature control range: -50 to 110℃(-58℉-230℉);
- High accuracy: 0.1℃
- With waterproof sensitive NTC (10K 0.5%) sensor probe as the measuring input.
- Digital LED Tubes: "LL" indicates sensor open, "HH" indicates overrange, the relay will be forcibly disconnected
- Long press the "SET" button to enter the main menu settings, press " + or - " to switching between P0-P5,then long press "SET" or 10 seconds without keystrokes to confirm the setting and return
- Controller automatically performs the relay ON/OFF.the thermostat output is 10A relay, meet a variety of high-power loads
Specifications:
- Temperature range :-50-110 ℃
- Temperature control mode: ON / OFF
- Resolution：When temperature is 0.1℃, the resolution is -9.9~99.9, other temperature segment is 1℃
- Control accuracy: 0.1 ℃
- Hysteresis accuracy: 0.1℃
- Refresh rate: 0.5S
- High temperature protection： 0-110℃
- Supply voltage: DC 12V
- Static current: ≤ 35MA, attract current ≤ 65MA
- Output voltage: DC 12V
- Output power: 20A relay
- Measurement input: NTC (10K 0.5%) Waterproof Sensor
- Environmental requirements: -10 ~ 60 ℃ ,Humidity 20% -85%,Sensor Probe Length:1m/39.37inch
- Dimensions: 1.89X1.57 inch.
How to use:
- P0 :Cooling/Heating; Range: C/H; Default: C
- P1 :Hysteresis Setting; Range:0.1-15; Default: 2
- P2 :Highest Setting Limit; Range:110; Default: 110
- P3: Lowest setting Limit; Range:-50; Default: -50
- P4 :Temperature Correction; Range:-7-7℃; Default: 0℃
- P5: Delay Start Time; Range:0-10 Minute; Default: 0
- When the Thermostat is power off, long press "- or +", you can restore the factory settings Connect the power supply and the load, you can supply to the controller, Is displayed as a measured temperature
- Press the SET button, the display flashes the temperature
- Press - to set the desired temperature
- After setting press SET to confirm return
- The controller automatically performs the relay by setting off!
- Lights, LED status descriptions:Indicator: Off The relay is switched off, Always indicate the relay is closed.
- LED: Shows LL is the sensor open, showing HH is out of range, the thermostat will be forced to close the relay.
Parameter Function:
- Long press SET 5 seconds to enter the main menu settings, press the - toggle P0 ... P5 long press SET or 10 seconds of no key activity confirmed their return to the controller.
Package included:
- 1x Temperature control switch
